Professional Data Recovery Services

Home	Process	Get Quote	Models	Typical cases	Sounds	Shipping	FAQ	Partnership	Contact

Fujitsu MPB3052AT Data Recovery Information

These are some real problems experienced by MPB3052AT and Fujitsu hard drives in general.

It's an external drive from LaCie with Fujitsu, p/n: MPB3052AT drive inside. When we plug in a pc, no drive appears in the tray. The drive has fall on floor. Our utility have detected some bad sector.
Layla L.
Charlottetown, Prince Edward Island, Canada

Fujitsu hard drives are widely known in data recovery business for their line of MPG hard drives several years ago that had faulty Cirrus Logic chips. Fujitsu manufactured about 5 millions of these hard drives and in November 2002 after a massively reported data losses have admitted the problem. The blame was laid on the supplier of epoxy mould compound used in the manufacture of Cirrus' Himalaya 2.0 and Numbur chips. It was claimed that supplier of the epoxy, a Cirrus Logic sub-contractor - made the first of several changes to its product, and it was this that ultimately caused the chips to fail by short-circuiting thus making the drive faulty and data inaccessible. After several months of use hard drives usually stop to spin up, behave erratically, start clicking etc. Nowadays these otherwise nearly ideal devices are mostly extinct but still sometimes we get them into our data recovery lab and in 100% of the cases we get all data back thanks to Fujitsu perfect mechanics.

Unfortunately this story shook Fujitsu reputation badly and they never manufactured 3.5" IDE drives anymore. Today only drives for laptops and those with SCSI interface can be seen. They are quite rare guests in our lab, thanks again to Fujitsu next to ideal mechanics and firmware implementation.

Computer power supply failed. Upon reinstall of new power supply, computer booted up for a few minutes before the hard disk controller card failed (smoke, melted foam under controler card, etc.) and computer rebooted, displayed "Can't find operating system." Tried swapping out a controller card from different hard disk of the same model (I thought), but found out the new disk was a Fujitsu - MPB3052AT. Disk was not recognized in BIOS and computer would not boot.
Arianna R.
St.John's, Newfoundland, Canada

Among the typical mechanical problems 2.5" laptop Fujitsu come into our lab are

bad heads with clicking, knocking or sweeping symptoms , and
heads being stuck to the platters so the drive can't spin up at all.

In both cases these drives need to be opened in class 100 clean room environment in order to retrieve data. Do not attempt to open the hard drive at home - you could scratch the surface and make all your data unrecoverable.

head sticktion to the platter - MPB3052AT

Bad sectors is another common problem for all manufactured hard drives and laptop Fujitsu drives in particular. After some period of time magnetic media the platters are covered with starts to degrade and magnetic domains can't turn in the desired direction by writing element of the head. This is how bad sectors appear.
When the drive starts reading data from such unreadable bad sector it could start freezing, scratching and sometimes even clicking

. This leads to further damage to the surface, heads and causes more data loss. As soon as you start experiencing such symptoms while reading important files stop the drive immediately and send it to our data recovery lab. Any further attempts would just add up to the problems. In our lab we use special imaging hardware tools that are capable of reading raw sector data ignoring checksum check. That's usually the only way to retrieve as much data as possible from such LBAs.

If you experience any of the symptoms described above with your Fujitsu MPB3052AT please feel free to contact us to get upfront quote on data recovery from your failed drive.

If you hear your Fujitsu MPB3052AT hard drive making some other unusual noises visit our Hard Drive Sounds page for more details.